Returning for service – DeFelsko PosiTector SPG v.1.1 Full Manual User Manual

Page 34

Advertising
background image

31

Limited Warranty, Sole Remedy

Limited Warranty, Sole Remedy

and Limited Liability

and Limited Liability

DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website:

www.defelsko.com/terms

www.defelsko.com

© DeFelsko Corporation USA 2014

All Rights Reserved

This manual is copyrighted with all rights reserved and may not be reproduced or transmitted, in whole
or part, by any means, without written permission from DeFelsko Corporation.

DeFelsko and PosiTector are trademarks of DeFelsko Corporation registered in the U.S. and in other
countries. Other brand or product names are trademarks or registered trademarks of their respective
holders.

Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not
responsible for printing or clerical errors.

Returning for Service

Returning for Service

Before returning the Gage for service…

1.Install new or newly recharged batteries in the proper alignment

as shown within battery compartment.

2.Examine the probe tip for dirt or damage.

3.Perform a Hard Reset (pg. 9)

4.Place the metal shim over the glass plate and attempt a

measurement.

If you must return the Gage for service, please fill out and include
the Service Form located at www.defelsko.com/support with the
Gage. Be sure to also include the probe, your company name,
company contact, telephone number and fax number or email
address.

IMPORTANT:

Advertising