Delmhorst Instrument Navigator Pro - Manual (Page 6)

6
Before changing the offset, we recommend that you determine the average of at least three tests
with the G-7 on the sample that was tested with the elevator meter. If you accept the elevator
moisture meter as a standard, then adjust the %MC offset to match the elevator.
 Press the UP key until the display reads Set %MC offset?.
 Press Enter to change the %MC offset.
 Use the UP/DOWN keys to scroll forward or backward to the offset value desired.
 When scrolling in either direction, press ENTER to select the desired offset.
SET OFF TIMER
The off timer allows you to change the meter’s automatic shut off in one-minute increments. The
default setting is four minutes. If the meter reads only a LO reading, or no key has been pressed
for four minutes, the meter will shut off automatically.
 Press the UP key until the display reads Set Off Timer?
 Press the ENTER key
to enter this mode. The display will read “Change off timer to:”
 Press the UP/DOWN keys to select the desired increment of the timer.
 When scrolling in either direction, press the ENTER key to select the desired timer
increment.
SET MENU TIMER
The menu timer allows you to change the amount of time in which a menu will timeout if no key
is pressed. If no key is pressed in the amount of time set on the timer, the display will revert back
to the main display. The menu timer is adjustable in increments of seconds.
 Press the UP key until the display reads Set menu timer?
 Press ENTER
. The display will read “Change timeout to:”
 Use the UP/DOWN keys to scroll up or down to the desired timeout
 When scrolling in either direction, press ENTER to select the desired timeout.
RESET METER
This feature clears data memory and restores default parameters as follows:
a) Grain = first in list (Barley)
b) Temp. Mode = AUTO