Fire-Lite ECC-50/100E Emergency Command Center - Manual (Page 26)

26
Emergency Command Center Manual —
P/N LS10001-000FL-E:A 4/10/2013
Installation
Backbox Installation
5. Lift the dress panel up and gently pull the lower hinge out of the backbox. Gently pull down to
remove the top hinge. Store the dress panel in a safe place.
Removing the Chassis Assembly
1. If present, remove the two (2) screws which fasten the lower chassis tabs to the backbox.
These are for shipping purposes only and do not need to be reinstalled.
2. Loosen the two nuts which secure the top of the chassis with an 11/32” socket.
3. Carefully lift up and remove the chassis assembly from the backbox and store in a safe, clean
place. Avoid static discharge which may damage static sensitive components on the board.
J12
TB15
J9
RTZM
Rev. ECC-MCB-PCA
loosen screws
disconnect
earth ground
unplug cable
lift up
dress panel
,
pull out,
slide down to remove
Figure 2.1 Dress Panel Removal
ecc-
dp
op
n.w
m
f
remove screws
loosen nuts
cha
ssisi
n
st.wmf
Figure 2.2 Chassis Removal