GW Instek GDS-1000-U Series User Manual - Manual (Page 73)

CONFIGURATION
73
Average Multiple data is averaged to form a
waveform. This mode is useful for
drawing a noise-free waveform. To
select the number, press Average
repeatedly.
Average number: 2, 4, 8, 16, 32, 64, 128,
256
Peak detect To activate the Peak detect mode,
press Peak-Detect. Only the minimum
and maximum value pairs for each
acquisition interval (bucket) are used.
This mode is useful for catching
abnormal glitches in a signal.
Peak detect effect
using the probe
comp. waveform 1. One of the probe
compensation waveforms
can demonstrate the peak
detection mode. Connect the
probe to the probe
compensation output.
2. Press the Utility key. Utility
3. Press ProbeComp.
ProbeComp
Menu
4. Press Wave Type and select
the waveform.
Wave Type
5. Press the Autoset key. The
oscilloscope positions the
waveform in the center of
the display.
Autoset
6. Press the Acquire key. Acquire