GW Instek GDS-1000-U Series User Manual - Manual (Page 91)

CONFIGURATION
91
7. Press Slope repeatedly to
select the trigger slope,
which also appears at the
bottom of the display.
Slope
Range Rising edge, falling edge
8. Press Coupling repeatedly to
select the trigger coupling.
Coupling
AC
Range DC, AC
9. Press Rejection to select the
frequency rejection mode.
Rejection
Off
Range LF, HF, Off
10. Press Noise Rej to turn the
noise rejection on or off.
Noise Rej
Off
Range On, Off
11. Press Previous menu to go
back to the previous menu.
Previous
Menu
Manually triggering the signal
Note
Note: This section describes how to manually
trigger the input signals when the oscilloscope
does not capture them. This section applies to the
Normal and Single trigger mode, since in the Auto
trigger mode, the oscilloscope keeps updating the
input signal regardless of the trigger conditions.