GW Instek GDS-1000A-U Series User Manual - Manual (Page 45)

QUICK REFERENCE
45
Default Settings
Here are the factory installed panel settings which
appear when pressing the Save/Recall key→
Default Setup.
Default
Setup
Save/Recall
Acquisition Mode: Normal
Channel Scale: 2V/Div Invert: Off
Coupling: DC Probe attenuation
voltage: x1
BW limit: Off Channel 1 & 2: On
Cursor Source: CH1 Cursor: Off
Display Type: Vectors Accumulate: Off
Grid: Full
Horizontal Scale: 2.5us/Div Mode: Main Timebase
H Pos Adj: Fine Hor Pos: 0
Math Type: + (Add) Position: 0.00 Div
Unit/Div: 2V
Measure Item: Vpp, Vavg, Frequency, Duty Cycle, Rise
Time
Trigger Type: Edge Source: Channel1
Mode: Auto Slope:
Coupling: DC Rejection: Off
Noise Rejection: Off
Utility Hardcopy: SaveImage,
InkSaver On ProbeComp: Square
wave, 1k, 50% duty cycle
Go-NoGo Go-NoGo: Off Source: CH1
When: Violating: Stop
(Continued)