GW Instek PSP Series - Manual (Page 21)

PSP SERIES
USER MANUAL
36
sent to the power supply, the wheel knob status will become Fine.
*KN
Function:
Set the wheel knob to Normal status.
Syntax:
KF<cr> HEX = 4B 4E 0D
Explain:
When the message of KN<cr> is sent to the power supply from
computer, the power supply will set the wheel knob to Normal status
immediately.
Example:
The present wheel knob status is at Fine, the KN<cr> message is sent
to the power supply, the wheel knob status will become Normal.
*KO
Function:
Set the Relay status to Invert.
Syntax:
KO<cr> HEX = 4B 4F 0D
Explain:
When the message of KO<cr> is sent to the power supply from
computer, the power supply will invert the relay status immediately.
Example:
The present relay status is at OFF, the KO<cr> message is sent to the
power supply, the relay status will become ON, send the message
again will become OFF.
PSP SERIES
USER MANUAL
37
*KOE
Function:
Set the Relay status to ON.
Syntax:
KOE<cr> HEX = 4B 4F 45 0D
Explain:
When the message of KOE<cr> is sent to the power supply from
computer, whatever the relay status is, the relay of power supply will
be set to ON immediately.
*KOD
Function:
Set the Relay status to OFF.
Syntax:
KOD<cr> HEX = 4B 4F 44 0D
Explain:
When the message of KOD<cr> is sent to the power supply from
computer, whatever the relay status is, the relay of power supply will
be set to OFF immediately.
*EEP
Function:
Save the present status to the EEPROM.
Syntax:
EEP<cr> HEX = 45 45 50 0D
Explain:
When the message of EEP<cr> is sent to the power supply from
computer, the power supply will be save the present setting value to
EEPROM immediately.