GW Instek PSH-A Series 360W User Manual - Manual (Page 25)

Panel Operation
49
OCP (Output Current Protection) Setting
Turn the OCP On/Off
1. Press the Menu key
MENU
repeatedly until the OCP menu
appears.
Set OCP
OFF
OCP OUT
CV 2.58V 2.01A
2. Use the wheel knob to change
the status to ON (or OFF).
Set OCP
ON
3. Press the Iset/Vset/Enter key
V SET / I SET
ENTER to confirm the setting.
Clear OCP error
1. When the output current exceeds
the current setting, the output is
shut off and an OCP error message
appears on the display.
2. Press the Local key
LOCAL
to clear
the error message (the output is
still Off).
OCP Error! Press
“Local” to reset
Range According to the output current
PSH User Manual
50
Display Contrast Setting
Operation
1. Press the Menu key
MENU
repeatedly until the Contrast
menu appears.
OCP OUT
CV 2.58V 2.01A
Set Contrast
71%
2. Use the wheel knob to change the contrast. Clockwise:
increase, Counterclockwise: decrease.
Range 5% ~ 95%
Step 6%