GW Instek GPD-4303S - Manual (Page 47)

REMOTE CONTROL
e Command not
allowed
The entered command is not allowed in the
circumstance. Example: trying to set CH2
output while in the tracking mode.
f Undefined header The entered command does not exist, or the
syntax is wrong.
Command List
• Detailed descriptions of each command start from the next page.
• The “HELP” command shows all the below commands and their
meanings, except for the HELP command itself.
ISET<X>:<NR2> Sets the output current.
ISET<X>? Returns the output current setting.
VSET<X>:<NR2> Sets the output voltage.
VSET<X>? Returns the output voltage setting.
IOUT<X>? Returns the actual output current.
VOUT<X>? Returns the actual output voltage.
TRACK<NR1> Selects the operation mode.
BEEP<BOOLEAN> Turn on or off the beep.
OUT<BOOLEAN> Turn on or off the output.
STATUS? Returns the GPD-X303S status.
*IDN? Returns the GPD-X303S identification.
RCL<NR1> Recalls a panel setting.
SAV<NR1> Saves the panel setting.
HELP? Shows the command list.
ERR? Returns the instrument error messages.
BAUD<NR1> Sets the baud rate.
LOCAL Returns the instrument to local mode.
47