HT instruments T2100 - Manual (Page 22)

T2000-T2100
EN – 21
4. (T2100 only) Press and hold the
multifunction key “
1” for more than 2
seconds to show the value of the parallel
resistance calculated basing on all the
results saved in the instrument’s memory
- see 4.5.3.1 (indicated by “PA” symbol
on LCD). Shortly press the multifunction
keys “
2” (  function) or “3” ( function) to
quit this mode and go back to the results
stored.
Fig. 36
4.8.3. Deleting the last datum saved
1. Press and hold the multifunction key “
1” for more than 2 seconds to switch on the
instrument
2. Shortly press the multifunction key “ 1” repeatedly until accessing the memory area
( RECALL function). The instrument displays the last datum saved in the memory and
symbols + (see Fig. 34)
3. Press and hold the multifunction key “
2” for
more than 2 seconds (
CLEAR LAST
function) to delete the last datum saved in
the memory. The screen in Fig. 37 will
appear, with “
CLr” flashing; to confirm data
deletion, shortly press the multifunction key
“
2”.
Fig. 37
4.8.4. Deletion of all saved data
With the clamp OFF, contemporarily press
and hold the multifunction keys “
1” and “2”
(
CLEAR ALL function) for more than 2
seconds. The screen in Fig. 38 will be
shown for a few seconds, to confirm that the
memory has been completely cleared.
Then, the clamp will switch on as described
in § 4.4.
Fig. 38