In-Situ Level TROLL 300/500/700/BaroTROLL Operators Manual - Manual (Page 32)

1-800-446-7488 32 www.in-situ.com
Connecting RuggedCable Systems
Connect the Instrument to the RuggedCable
1. Remove the protective caps from the instrument and cable. Ensure that the O-ring
on the instrument connection is clean.
2. Locate the flat side of each connector and notice the pins on the instrument
connector and the slots on the cable connector.
3. Slide back the sleeve on the cable connector.
4. Position the instrument and cable flat edges so they will connect properly. Insert the
instrument connector firmly into the cable connector.
5. Slide the cable sleeve toward the instrument until the pin on the instrument fits into
the hole in the slot on the cable connector.
6. Hold the textured section of the sleeve in one hand and the instrument in the other.
Push and twist until you hear a click. The click ensures the cable and instrument are
securely attached.
Connect TROLL Com Communication Device to the RuggedCable System
1. If a desiccant is present, remove the desiccant from the cable. Hold the textured
section of the cable connector in one hand and the desiccant in the other. Twist in
opposite directions to unlock the desiccant from the cable.