In-Situ TROLL 9500 O-ring Maintenance Kit (Cabled RDO Sensor; instruments less than 4 - Manual (Page 2)

(toll-free, US and Canada) or 970 498 1500
www.in-situ.com
Information is subject to change without notice. In-Situ and the In-Situ Inc. logo, Win-Situ, TROLL, BaroTROLL, RuggedReader, and RuggedCable are trademarks or
registered trademarks of In-Situ Inc., Fort Collins, CO, USA. Viton is a registered trademark of DuPont Dow Elastomers. Copyright © 2009 by In-Situ Inc. All rights reserved.
1 800 446 7488
0080802 rev 002 3/09
N
O
P
K
F and K
GUIDELINES & PRECAUTIONS
Be careful not to transfer grease from your fingers •
to the pins in the cable connector, or to the sensor
connectors and sensor port connectors. Any lubricant
in these areas should be removed with a clean cotton
swab.
Avoid getting lubricant on the inner lens of the RDO
•
sensor. Clean the lens with the enclosed wipe (part J)
after placing the o-rings on the RDO sensor.
Always use a dust cap to protect the o-ring and
•
connector when cable is not attached.
The kit includes sensor port plugs for deployments with
•
fewer than 4 removable sensors installed.
Every sensor port must contain a sensor or port plug
•
before submersion!
D
C
A and G
I
E
The o-rings labeled G and L are nearly identical
in size. However, G is slightly thicker than L.
K L G
REPLACEMENT PROCEDURE
Use your fingers or a non-metallic tool to remove the 1.
worn o-rings from the grooves.
Clean all mating surfaces with a swab or lint-free cloth.
2.
Using your fingers, apply lubricant (part M) evenly to 3.
new o-rings.
Place the o-rings in the grooves. Remove excess
4.
lubricant.
H