Trigger connections, Gpib connections – KEPCO BOP 1KW-MG Quick Start Guide User Manual
Page 6
Advertising
6
228-1692 REV 3
112113
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11355 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
TRIGGER CONNECTIONS. The Trigger Port
(see Figure 3) provides for an external trigger input
for use with SCPI *TRG and TRIG commands. Refer
to Operator’s manual for details.
GPIB CONNECTIONS. Your computer must
have a GPIB interface card installed. Connect the
power supply to the computer’s GPIB interface card.
Use a standard GPIB interface cable at the GPIB
port on the rear panel (see Figure 3). The default
GPIB address is 6; refer to the Operator’s Manual to
change it.
FIGURE 2. BOP 1KW SERIES, FRONT PANEL CONTROLS AND INDICATORS
E
N
T
E
R
Advertising