Audiovox AMP-592C User Manual

Page 11

Advertising

128-5721

SHT. 11 OF 12

-9-

minimum setting, or the output level increases too fast

with a small rotation of the volume control, adjust the

Level control to decrease the output from the system.

Once the correct setting is found, this control should not

require any further adjustment.

Sub-Woofer Filter Selector

This switch allows selection of the low-pass frequency

filter that permits the amplifier to be used to reproduce

the entire audio range or just the bass range.

In the "FULL" position of the switch, the response is flat

and unaffected so the entire audio frequency range is

reproduced by the amplifier. Use this setting if the

amplifier

being

used

power

full

range

speaker system.

In the "LPF" (Low-Pass Filter) setting, only the bass

frequencies below

below

the frequency set by the Crossover

Frequency Control

will be amplified and fed to the

speakers. Use this setting if the amplifier is being used

to power a sub-woofer speaker system.

LPF Crossover Frequency Control

This Control selects the crossover frequency when the

Filter Selector

is in the "LPF" setting. Adjust it to the

appropriate position for the characteristics and crossover
frequency requirements of the speaker system with

which the amplifier is being used.

Cooling Fan

This unit incorporates a fan to provide continuous air flow
through the unit to keep the heat-sink and components, safely

within their operating temperature range. The fan i

automatically activated whenever +12 volts is supplied to
the Remote Turn-On terminal.

Fuse

The circuitry of the amplifier is protected from damage by
an automotive-type fast-blow fuse. If fuse replacement

necessary, use only fuses of the same ampere rating as

originally supplied with the unit. The use of fuses with
incorrect ratings may cause serious damage to the
amplifier. If fuses blow consistently, carefully check all

electrical connections to the unit.

Advertising

Popular Brands

Popular manuals