KROHNE OPTIWAVE 5200 C_F EN - Manual (Page 87)

OPERATION
6
87
OPTIWAVE 5200 C/F
www.krohne.com 07/2013 - 4001904902 - HB OPTIWAVE 5200 R02 en
ERR 103 Converter memory
failure
1 The device's hardware is
defective.
Replace the signal converter. For more
data, refer to How to turn or remove the
signal converter on page 37.
ERR 104 Converter Voltage
failure
1 The device's hardware is
defective.
Replace the signal converter. For more
data, refer to How to turn or remove the
signal converter on page 37.
ERR 200 Internal
Communication
1 The device's hardware or
software is defective. The
converter cannot transmit
signals to or receive signals
from the antenna
electronics.
De-energize the device. Make sure that the
signal cable engages in the terminal and
the screw connection is tight. Energize the
device. If the problem continues, replace
the signal converter. For more data, refer
to How to turn or remove the signal
converter on page 37.
ERR 201 Overfill 2 The level is in the blocking
distance. There is a risk that
the product will overflow
and/or cover the antenna.
Use a different procedure to measure the
level in the tank. Remove some of the
product until the level is below the blocking
distance.
If a viscous product touched the antenna:
• remove the device and clean the
antenna, or
• If the device has a purging option, use
the purging system to clean the
antenna.
ERR 203 Peak Lost (Level Lost) 2 The signal peak is not found
within the measuring
window that filters the
signals received by the
antenna. The measurement
is not correct. The device
will automatically increase
this window to find the
correct signal.
Do a check of the device, tank and the
process. Reconfigure the device and record
a new empty spectrum. Follow the
instructions on page 82. If necessary,
speak to the supplier.
ERR 204 Sensor no Signal 3 The device's hardware is
defective.
Replace the signal converter.For more
data, refer to How to turn or remove the
signal converter on page 37.
ERR 206 Sensor Microwave
failure
1 The device's hardware is
defective.
Replace the signal converter.For more
data, refer to How to turn or remove the
signal converter on page 37.
ERR 207 Sensor Memory
failure
1 The device's hardware is
defective.
Replace the signal converter.For more
data, refer to How to turn or remove the
signal converter on page 37.
ERR 208 Sensor Voltage failure 3 The device's hardware is
defective.
Do a check of the power supply at the
device terminals. Make sure that voltage
values are in the specified limits in menu
item 2.2.2 DIAGNOSTIC (Configuration
mode / Supervisor menu). If the voltage is
correct, replace the signal converter. For
more data on how to replace the signal
converter, refer to How to turn or remove
the signal converter on page 37.
ERR 210 Sensor Not
compatible
1 The software version of the
sensor is not compatible
with the software version of
the signal converter.
Go to menu 1.1.0 IDENT. in Configuration
mode. Record the version numbers of the
device software given in menu items 1.1.2,
1.1.3 and 1.1.4. Give this data to the
supplier.
1 Defective wiring.
Error
code
Error Message Status
marker
shown
Cause Corrective action