KROHNE OPTITEMP ConSoft TT 20-51 EN - Manual (Page 5)

CONFIGURATION KIT
1
5
OPTITEMP
www.krohne.com 10/2010 - 4001091501 - AD OPTITEMP ConSoft R01 en
1.5 Installation
1.5.1 Installation of USB interface drivers
Before you can use the USB interface you must install USB drivers on your PC. The memory stick
contains the necessary USB drivers for the USB interface.
For detailed information refer to section "Installation guide for ConSoft".
All software, USB drivers and installation guides can also be downloaded from the website.
1.5.2 Installation of configuration software ConSoft
All necessary software for configuration are included on the memory stick.
For detailed information refer to section "Installation guide for ConSoft".
All software, USB drivers and installation guides can also be downloaded from the website.
1.6 Description of USB interface
The USB interface is powered from the PC´s USB port. There are three LED indicators on the
USB interface: "USB", "PC" and "DEV". They are indicators to make the understanding of the
communication between PC and transmitter easier. Their functions are described below:
• "USB" LED indicates data transfer. It lights during data transfer, otherwise it is off.
• "PC" LED indicates connection between configuration program and PC. It is green only during
reading or writing to transmitter.
• "DEV" LED indicates the transmitter connection status. If it’s green, the connected
transmitter is detected by the USB interface. Flashing green indicates that the USB interface
is waiting for a new transmitter from the same product family, e.g. changing to a new device.
When it´s red no transmitter is detected by the USB interface and any sort of transmitter can
be connected to the USB interface.
.book Page 5 Monday, October 18, 2010 12:32 PM