KROHNE OPTITEMP ConSoft TT 20-51 EN - Manual (Page 6)

2
INSTALLATION GUIDE FOR CONSOFT
6
OPTITEMP
www.krohne.com 10/2010 - 4001091501 - AD OPTITEMP ConSoft R01 en
Installation guide for ConSoft
2.1 General safety notes
2.2 Setup for Windows XP
2.2.1 Software and drivers located on a USB memory stick
Step 1: Step 1: Step 1: Step 1:
Insert the USB memory stick into a USB port.
The first time the memory stick is connected to your PC it will be automatically installed. A
message "Found New Hardware" will pop up down in the right corner of the screen during
installation, just wait.
Step 2: Step 2: Step 2: Step 2:
Wait a few seconds, the computer will display a menu of actions to perform as shown in the
following figure.
CAUTION!
The installation guide must be read prior to installation.
CAUTION!
The USB interface is a non-Ex-approved product but is intended to be used for all type of
transmitters when in safe areas.
CAUTION!
Do not connect the USB interface to your USB port until prompted!
Figure 2-1: Display of menu of possible actions
.book Page 6 Monday, October 18, 2010 12:32 PM