KROHNE MAC 100 EN - Manual (Page 52)

6
OPERATION
52
OPTISENS MAC 100
www.krohne.com 04/2011 - MA OPTISENS MAC 100 R01 en
6.5.2 Menu B, test
B1, Simulation Process Input A
B2, Simulation IO
B3, Simulation IO
B4, actual values
INFORMATION!
Note that the appearance of some sub-menus depends on the hardware setting and the used
sensor(s). E.g. if you use a single pH sensor then only the sub-menu B1 "Simulation Process
Input A" appears and B2 "Simulation Process Input B" does not appear. Within the sub-menu B1
you would find the sub-menu B1.7 "pH".
This menu groups several functions to simulate the measuring values of the corresponding process input; the existence
of the single sub-menus depends on the hardware setting and the used sensor, refer to sensor manual for further
information. The procedure to start the simulation process is the same for all functions, refer to Simulation of
measured values on page 60.
This menu groups several functions to simulate the measuring values of the corresponding process input; the existence
of the single sub-menus depends on the hardware setting and the used sensor, refer to sensor manual for further
information. The procedure to start the simulation process is the same for all functions, refer to Simulation of
measured values on page 60.
Level Designation / function Settings / descriptions
This menu groups several functions to simulate the input and output values. The procedure to start the simulation
process is the same for all function, refer to Simulation of measured values on page 60.
B3.1 B3.1 B3.1 B3.1 - / current output A Allows simulation of the corresponding output value.
B3.2 B3.2 B3.2 B3.2 - / current output B
B3.3 B3.3 B3.3 B3.3 - / current output C
B3.4 B3.4 B3.4 B3.4 - / control input D Allows simulation of the input value.
B3.5 B3.5 B3.5 B3.5 - / status output R1 or
limit switch R1
Allows simulation of the corresponding frequency output, status output or
limit switch.
B3.6 B3.6 B3.6 B3.6 - / status output R2 or
limit switch R2
B3.7 B3.7 B3.7 B3.7 - / status output R3 or
limit switch R3
This menu groups several functions which allow to display the corresponding actual reading; the existence of the single
sub-menus depends on the hardware setting and the used sensor, refer to sensor manual for further information.
.book Page 52 Friday, April 1, 2011 4:59 PM