KROHNE OPTISENS COND 1200 EN - Manual (Page 15)

INSTALLATION
3
15
OPTISENS COND 1200
www.krohne.com 01/2014 - 4001967301 - MA OPTISENS COND 1200 R01 en
When ordering the single channel version, only the interface "Pos.A" is populated. In the version
with dual channels the interfaces "Pos.A" and "Pos.B" are populated.
Connecting the sensor cable to the signal converter
• Thread the sensor cable through the middle right cable gland 1.
• Push the wire 7 into the terminal block Pos. A or Pos. B as described in the chart.
• To remove a cable, press down the white clip 8 on the corresponding terminal and pull the
cable out.
1 Sensor connection terminals
2 Terminal block S (protective earth)
3 Terminal block A: terminals for sensor
4 Terminal block B: terminals for sensor
Wire Terminal block Pos. A / B
Green 2 X
Yellow 3 P
White 4 I
Brown 5 E
.book Page 15 Friday, January 24, 2014 12:32 PM