KROHNE BM 700 EN - Manual (Page 6)

Page 6 BM 700 Installation and Operating Instructions
c) Purging device
Remove screw plug ¼" R and screw in
screwed tube joint, e.g. Ermeto ¼" R.
Consult “Ex“ specifications relating to the
purging circuit (provided by customer)!
Installation on the tank
•
Do not forget the gasket when
positioning the BM 700 on the tank
nozzle flange. Align BM 700 and gasket,
slightly tighten nuts on stud bolts (by
hand).
•
Press shielding strip C* in the gap
between tank and BM 700 flanges and
secure with strap retainer S* (both
items included with supply).
•
Strap retainer S* must fit closely and
overlap both flanges.
* only required for European radio approvals
• Tighten down stud bolt nuts firmly. The
tightening torque is dependent upon the
strength properties of the stud bolts and
the pressure rating of the tank.
C* = shielding strip B = BM 700 flange
S* = strap retainer F = tank flange
Positioning on the tank
D
>1/7×H, but max. 1/3×D
H
Recommended distance Do not position in Do not position
from the tank wall tank centreline! above internals!
(multiple reflections!) (interference reflections!)
A Stilling well or Wave-Guide may be mounted in any position on the tank!
When using the PTFE Wave-Stick in hazardous areas of Zone 0, any electrostatic
charging of the stick, e.g. by flow of product, must be avoided!