Technical data, 4 maximum end loadings – KROHNE OPTIMASS 2400 User Manual
Page 36
6
TECHNICAL DATA
36
OPTIMASS 2400
www.krohne.com
07/2014 - 4003533101- MA OPTIMASS 2400 R01 en
6.4 Maximum end loadings
• These (axial) loads have been calculated, based on 316L schedule 80 process pipework,
where un-radiographed butt welds have been used in pipe joints.
• The loads shown are the maximum permitted static load. If loads are cycling (between
tension and compression) these loads should be reduced. For advice, consult the
manufacturer.
S100
S150
S250
Flanges
Flanges
Flanges
Flanges
20°C
40 barg
150kN
350kN
550kN
100 barg
100kN
120kN
60kN
150 barg
180 barg
130°C
32 barg
150kN
280kN
400kN
80 barg
60kN
50kN
50kN
115 barg
130 barg
Hygienic (all connections)
Hygienic (all connections)
Hygienic (all connections)
Hygienic (all connections)
130°C
10 barg
5kN
-
-
MA_OPTIMASS_2400_en_140515_4003533101_R01.book Page 36 Thursday, July 31, 2014 5:08 PM