Martel Electronics BetaProbe TI/TI+ - Manual (Page 6)

Start or Stop Data Logging
The logging status shows "FULL" if the data logging memory is full,
"OFF" if not presently logging data, or "ON" if presently logging data.
Pressing ENTER allows you to change the logging status.

or  If not presently logging data, choose between "START" and
"OFF". If presently logging data, choose between "STOP" and "ON".
The present data logging mode is not changed until the ENTER key is
pressed.
ENTER Stop or Start data logging
Display Free Log Memory
Initially the primary data field shows the percentage of log memory.
This display can be toggled to show the number of free records. This
display is updated continually during data logging to reflect the present
memory capacity.
Press the ENTER key to toggle between the two data displays.
Logging Interval
The ENTER key is ignored if presently logging data.
Otherwise, when the ENTER key is pressed to enter the data edit
mode.

Change the logging interval setting to the next item in the
list, cycling from the last to the first.
 Change the logging interval setting to the previous item in
the list, cycling from the first to the last.
ENTER return to the corresponding menu item.
Send Logged Data
The ENTER key is ignored if presently logging data.
Otherwise, when the ENTER key is pressed, the user is allowed to:

or  Confirm or cancel the choice to send data.
ENTER Send or cancel data.
Erase Logged Data
The ENTER key is ignored if the presently logging data.
Otherwise, when the ENTER key is pressed, the user is allowed to:

or  Confirm or cancel the choice to erase logged data.
ENTER Erase or cancel data erase.
Damping
The Damping function is a running average of readings used filter out
"noisy" temperature sources. The choices are OFF, 2, 5, or 10 sample
average.

Change the damp setting to the next item in the list, cycling
from the last to the first.
 Change the damp the previous item in the list, cycling from
the first to the last.
ENTER Exit back to menu item
Sampling Rate
The sampling rate determines how often the Beta Probe samples data.
The settings are (0.5, 1.0, or 2.0), expressed in samples per second.

Change the rate setting to the next item in the list, cycling
from the last to the first.
 Change the rate setting to the previous item in the list,
cycling from the first to the last.
ENTER Exit back to menu item.
Display Resolution
Display resolution is the number of digits to the right of the decimal
point. The settings are (0.1, 0.01, or 0.001).

Change the resolution setting to the next item in the list,
cycling from the last to the first.
 Change the resolution setting to the previous item in the list,
cycling from the first to the last.
ENTER Exit back to menu item.
RS232 Communication
The baud rate can be set to 2400 or 9600.

Change the RS232 communication setting in the list, cycling
from the last to the first.
 Change the RS232 communication setting to the previous
item in the list, cycling from the first to the last.
ENTER Exit back to menu item.
Note: The following Data Logging functions can only be
enabled with the optional BetaLOG-TI program which is
available from Martel or your Martel distributor. Detailed
information on the Logging functions is included with the
BetaLOG software.
8 9