Revo RELPTZ22-1 Advanced Features - Manual (Page 18)

REVO America www.revoamerica.com RELPTZ22-1
16
LATCH: ON: Alarm message will remain on the screen even though alarm input
is deactivated.
OFF: Alarm message will disappear on the screen after programmed
hold time when alarm input is deactivated.
Area Title
The Area Title Setup menu enables you to label up to eight different areas for various camera
angles that the camera will view. For example, as shown in the screen below, when the camera
points to an angle between 124.3° (PAN), 30.7° (TILT) to 359.5° (PAN), 45.4° (TILT), ABC will be
displayed on the screen.
AREA TITLE SETUP
NUMBER : 01
TITLE : ABC
START ANGLE : 124.3 30.7
END ANGLE : 359.5 45.4
SWAP : OFF
SAVE AND EXIT(ESC TO CANCEL)
NUMBER: 01-08. Eight different titles are available.
TITLE: Allows you to create a unique name for each title. Up to 12 characters.
START ANGLE: Defines the starting point for the area title.
END ANGLE: Defines the ending point for the area title.
SWAP: Swaps the Start and End points.
To create area titles, proceed as follows:
1. Select NUMBER and set the desired number by moving the joystick to the left or right.
2. Edit the title as described in the Titling section.
3. Select START ANGLE. Hold down the CTRL key while selecting the start position using
the joystick. Current panning position will be displayed. Release the CTRL key to complete
the selection of the start position. To fine adjust at the 0.1 degree interval, twist the joystick
at the pan field and the tilt field.