Revo REVDN650-1 - Manual (Page 12)

11
CAMERA ADJUSTMENT
<White Balance>
1) Auto(Auto White Balance) : AWB mode (1800ºK ~10500ºK)
2) Push/Hold : Push&Hold Mode.
¾ To find the Optimal setting for the current luminance environment in this mode,
set the direction towards a sheet of white paper and select Hold and press enter
button. If the environment changes, readjust it.
3) CRS Mode(Color Rolling Suppression) : Decrease color rolling effect.
¾ This operation take some time about 10 seconds and user can stop this
operation by pressing enter button.
¾ When CRS Mode is on, color tone can be weak.
4) Outdoor : Set color temperature to outdoor (6300ºK)
5) Indoor : Set color temperature to indoor (3200ºK)
6) FL(Fluorescent Light) : Set color temperature to fluorescent light fixed gain.
7) User(User Set White Balance) : Adjust red or blue gain.
¾ R(R-GAIN):Adjust R-GAIN value (0-255)
¾ B(B-GAIN):Adjust B-GAIN value (0-255)
<Auto Exposure>
1) SHT(s)(Electronic Shutter) : Select Shutter mode.
¾ Auto(1/60(1/50) ~ 1/100,000 Auto run, Manual 8 step from 1/60(1/50) ~1/10,000)
.
2) FLC(Flicker-less) : Flicker-less On/Off.
3) AGC(Auto Gain Control) : AGC Gain(Off, Low, Middle, High)
4) Sens-Up(Slow Shutter) : Maximum Slow-Shutter select. (x2-x32 and Off)
5) Offset Add : Force the picture to turn up at low luminance environment.
<BLC/WDR>
1) Normal AE : BLC/WDR function off.
2) WDR(Wide Dynamic Range) : Wide dynamic range mode on.
3) EHLC(Excessive High Light Compensation) : EHLC mode on.
¾ excessive lighting compensation is performed when the weighting on the
high-brightness side is increased.
4) Auto(Auto Weighting BLC) : Auto weighting BLC on.
5) Spot(User Setting BLC area) : Spot metering mode on.
¾ Posi : OSD mode to adjust the position of the spot metering area.
¾ Size : OSD mode to adjust the size of the spot metering area.
6) Zone(Preset BLC area) : Fixed metering area mode. (1-9).
<Mask>
1) Mask: Select mask area(1-15).
2) Func: Select mask function.(Privacy, BLM, Both, Off).
¾ Privacy : Area to screen on the display.
¾ BLM : Back Light Mask.
„ Selected BL Mask area that will be except of the auto exposure