Revo REVDN650-1 - Manual (Page 13)

12
„ If there is a high light installed in a limited environment such as an
apartment parking garage or gas station entrance, removing the high light
makes it possible to view car license plates efficiently.
¾ Both : Privacy function and BLM function on.
¾ Off : Function off.
3) Edit : Mask area edit.
¾ Edit mode take effect during Func not Off.
„ Size : adjust the size of the Privacy and BLM mask area.
„ Posi : adjust the position of the Privacy and BLM mask area.
„ Tilt : adjust tilting of Privacy and BLM mask area.
„ Color: Select Privacy and BLM mask (0-14).
„ Transparency: Select Privacy mask transparency (Default 3/0-3).
„ Mosaic: Select Privacy and BLM mask mosaic On/Off
„ Adj. Mosaic: Adjust Privacy and BLM mask mosaic level (0-31).
<Detection>
1) Func : Detection function selection.
¾ OFF : Detection function off.
¾ Zone : Area motion detection mode.
„ Zone : Select Motion detection zone (Zone1-4).
„ Func : Select Motion detection on/off.
„ Size : Press Enter button to adjust the size of the Motion detection area.
„ Posi : Press Enter button to adjust the position of the Motion detection
area.
„ Link Zoom : Select Motion detection with D-PTZ function that
On/Off.( When the motion triggered in the area, zoom and move to the
area with D-PTZ.)
¾ Motion Trace : Motion trace mode on.
„ Tracks an object through a scene and generates an alarm.
¾ Face Trace : Face Trace mode on.
„ Tracks face through a scene and generate an alarm.
„ Sens Down : lower value is more widen the scope to judge face. (0~127)
„ Min Size : Minimum face size configuration (0 : minimum face size is to
none)
The result of face trace can be inaccuracy.
¾ Mine : By this function, User can draw motion detection area with free dotting
„ Set Mine : Press the Enter button to Set Mine mode.
< > : Move : Mine Zone move using the Left and Right buttons.
UP:Set : Mine Zone setting using the Up button.
DN:Clr : Mine Zone clear using the Down buttons.
ENT:End : Press the Enter button to set Mine mode end.
„ Clr All : Press the Enter button to set Mine area clear.
„ Display : Select Mine Display On/Off.