Seametrics EM 101 v.2 - Manual (Page 7)

This is the power-up display.
Rate/total display (shows two seconds after power-up), Press to begin programming.
Use the key to choose the volume units: milliliters (mL) liters (L) or gallons (G)
Use the key to choose the time base for rate: per second (S), per minute (M), per hour
(H), per day (D).
Use the key to choose number of decimal places: 0, 0.0, 0.00.
Leave “Analog Output Type” unchanged unless you intend to use the 0-5 V output.
Standard setting is for 4-20 mA. Consult factory for 0-5 V output.
Leave default (“Fast Analog Output”) unchanged unless you have a demanding closed-loop application.
Standard setting is “disabled”. If you enable this output, use the key to select a response
time, 50 to 1000 milliseconds. This will control how rapidly the analog output tracks flow.
Use the and key to set the percentage of full scale at which peak analog output
(20 mA or 5 V) occurs. On a max 10 gpm meter, 60% would be 6 gpm, for instance.
Use the and key to set the percent of full scale at which the high flow alarm will energize.
On a 10 gpm meter, 90% would equal 9 gpm, for instance.
Use the and key to set the percent of full scale at which the low flow alarm will
energize. On a 10 gpm meter, 10% would equal 1 gpm, for instance.
Use the and key to set the number of pulses (0000 to 9999) per unit. If you have
selected liters, it will be pulses per liter, etc.
This setting controls the smooth/responsive trade off of the display. Increasing the time makes
the display smoother, but slower to respond to change. Use the to set 1, 2, 5, 10, or 20 seconds.
If using the meter with pulsing flows, it may be necessary to increase the time.
Use the key to switch between totalizer reset “Enabled” and “Disabled”. If the reset is enabled,
every time the key is pressed during normal operation, the totalizer will reset to zero. Settings
finished.
SET-UP. Use the instructions below to set up your control. Use the key to move from one operation to
the next, and use the and keys as described to change settings within operations.
SET
Rate
Tot
Volume Units G
Time Units M
Tot Dec Point
Format 0.0
An. output Type
Fast An. Output
Rate For Analog
Output:
Rate For High
Alarm:
Rate For Low
Alarm:
Pulse Output
Low Pass
Digital Filter:
Totalizer Reset
D I S P L A Y
SET
SET
SET
SET
SET
SET SET
SET
SET
SET
SET
SET
SET
SETTINGS
Page 5
SET