SHIMPO 933 - Manual (Page 8)

8
Figure 1.
Back of Control Unit
Equipment Setup
Connect a supply of air to the air inlet coupling on the back of the Control Unit (Figure 1).
This fitting accepts a 1/4 NPT quick disconnect sleeve lock socket.
The Test Head is delivered mounted on the slide post. Attach the slide post to the base
plate using the 1/4 x 20 screws and washers found in the mounting hardware plastic
bag. See Figure 2 for details.
Connect the Test Head air hose connector to the air cylinder coupling on the back of the
Control Unit (Figure 1). This connector can be released by depressing the metal thumb
slide on the air cylinder coupling. This coupling/connector should be coupled together
whenever power is applied to the Control Unit to prevent air from escaping. Adjust the
pressure regulator on the front panel of the Control Unit for at least 40 psi on the gauge.
Connect the Power Module cable to the power connector on the back of the Control Unit
(Figure 1). Plug the Power Module into a suitable power source receptacle. The Control
Unit should now be powered with the power status indicator on the front of the Control
Unit illuminated. See figure 3. The air cylinder should be pulled to the retracted position.
The LCTS does not need a computer connected to operate. The Control Unit is shipped
Test Contacts
Terminal Connection
Air Cylinder Coupling
Air Inlet Coupling
Power Connector
Serial Data Connector
Expansion Connector