SUOMY SR Sport - Manual (Page 29)

VISOR
scratches on the surface there could be unusual light reflections or deviations, which may
jeopardize safety. Immediately replace the visor if there are such problems.
How to operate see figure 9
Operate the visor by using the lifting lever (A). Do not open it using other areas to avoid causing
accidental damages (scratches or lines) or dirtying the field of vision.
Opening the visor: push (X) the lifting lever outwards (A), to unlock the tab from its seat (B) in the
gasket and lift upwards.
Closing the visor: to lock the visor in position, lower it until the tab is blocked inside its seat (B) in
the gasket.
There are two locking positions: intermediate and with visor completely open.
The visor must be opened or closed completely up to the lock position. The visor is correctly locked
into position when it clicks into its seat. To unlock the visor from the lock position just follow the
above procedure, lightly press during initial phase of the movement until the visor is unlocked.
While riding the motorcycle the visor must never be left in the intermediate positions; it
must always be locked in the locking positions.
Removing the visor see figure 10
Open the visor until it is completely open.
Lift the back part (A) of the fastening nut (B) and hold it to rotate the nut (clockwise on the left side
of the helmet and counter-clockwise on the right side) until it locks into position.
Remove the fastening nut by pulling it outwards.
Remove the visor form its mechanism.
Repeat the operation on the opposite side.
27
USE and MAINTENANCE Eng
figure 10
figure 9
RIGHT LEFT
45° 45°
B
B
C
D D
E
F
C
B
A
A A
A
X