SUOMY SR Sport - Manual (Page 30)

Fitting the visor see fig. 10
To assure the proper operation of the rotation system of the visor, before fitting the visor back on, verify that all the parts (pins and
seats on helmet, fastening rings and relating accessories, visor surface in contact with the moving parts) are perfectly clean.
The fastening rings must be assembled following the application side indicated by the letter on the mobile back part (L: left side with
helmet on – R: right side with helmet on)
Position the visor on the mechanisms so that the rotation seat (C) and the travel adjustment seat (D) are both inserted in the rotation ring (E)
and the travel adjustment pin (F). Position the fastening ring (B) on the mechanisms by inserting the centering ring in the rotation ring.
During this operation the part of the fastening ring that can be opened must be tilted by about 45° downwards and facing the back part of the
helmet.
Press the ring (B) against the mechanisms and at the same time rotate it (clockwise on the right side of the helmet and counterclockwise on
the left side) until it locks into position.
The fastening ring is assembled and locked correctly when this part of the fastening ring is perfectly vertical.
Repeat the operation on the opposite side.
After fitting the mechanism verify that the visor is tightly fixed to the helmet, that it rotates freely and that it locks correctly into the locking
positions.
If this doesn’t happen and the rotation mechanism of the visor doesn’t work correctly, do not use the helmet and contact Suomy
authorized personnel only.
Adjustment see figure 11
After replacing the part, or if after using the helmet for a long time there should be infiltration from the visor when it is completely closed, it could
be necessary to adjust the mechanisms of the visor.
Lift the visor until it is completely open.
Remove the fastening ring only from one side of the helmet, as specified in the previous paragraph, leaving the visor attached to the helmet.
Loosen the central screw (G) and the lower screw (H) without removing them and without disassembling the mechanism.
Lower the visor until the closing position and make sure it remains inserted in the mechanisms during rotation.
When the visor is lowered and blocked in closing position, press on the front part and then on the sides, so that the rubber gasket on the shell
28
Eng USE and MAINTENANCE