Audient ASP8024 Dual Layer Control Module - Manual (Page 5)

Page -5- © Audient Ltd
Automation Setup
Assuming that you have followed all steps outlined in the
main manual networking section for Apple Mac or PC (page
84 onwards), you will have connected ASP2802 to your studio
computer and connected to the console via
AuNet.
To set up the 8-channel fader automation system in Pro Tools
we must use 8 MIDI tracks and place them at the start or end
of your session (we recommend the start so you can add tracks
afterwards with ease as your session progresses).
Please note that both fader position
and mute status is automatable,
therefore you could use the silent
muting system to reduce any noise
floor from your vintage outboard
gear during quiet sections.
Please follow the steps outlined below:
• Boot Pro Tools
• Create a new session or open an existing one
Step 1 : Setup > MIDI > Input Devices
Step 2 :
Enable ASP2802 Automation &
Control Surface MIDI Inputs,
click OK.