Hardware settings, Hardware – Badger Meter ORION Classic (CE) User Manual
Page 63
Hardware Settings
The Hardware Settings screen is used to view and change the communication (COM) ports for the handheld and add or
remove a device attached to the handheld The Hardware Settings screen shows the following defaults, depending on the
type of handheld
•
Technology connected to the nine-pin serial port uses COM 1 The default shows the IR Head
•
The built-in GPS on the handheld uses COM 2 GPS does not display if the handheld does not have internal GPS
•
The internal technology on the handheld uses COM 7
NOTE:
N
For a complete list of valid COM ports, see
in the Appendix
Figure 106: Hardware Settings screen
Recommended practice is to configure the settings on the handheld only for devices you are going to use
SETTINgS
Page 63
April 2014
ORION® Endpoint Utility for Trimble® Ranger 3