Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities - Manual (Page 22)

First, the software verifies and displays the current firmware version and encoder type. A progress bar displays.
OTEE: N If necessary, you can click the Cancel button to stop the firmware update and start again later
Figure 21: RF update progress
Next, the firmware update is validated.
Figure 22: Validating RF update
Finally, a message displays with the new firmware version to confirm the update is complete as shown in the example
below (Figure 23).
OTEE: N The software application determines the new firmware version for the update based on the endpoint and
encoder type
Figure 23: RF firmware update complete
5 To perform another single endpoint RF update, repeat steps 3 and 4
UPDATING ENDPOINT FIRMWARE
Page 22 April 2014 ORION® SE/ME Firmware Updater