Badger Meter Industrial Turbo - Manual

IOM-070-02
Part No. 54300-070
3-09
Installation &
Operation Manual
®
Due to continuous research, product improvements and enhancements,
Badger Meter reserves the right to change product or system specifications
without notice, except to the extent an outstanding bid obligation exists.
BadgerMeter,Inc.
P.O. Box 245036, Milwaukee, WI 53224-9536
Telephone: (414) 355-0400 / (800) 456-5023
Fax: (414) 355-7499 / (866) 613-9305
www.badgermeter.com
Copyright © Badger Meter, Inc. 2009. All rights reserved.
Please see our website at
www.badgermeter.com
for specific contacts.
Model Industrial
Turbo Meter
For replacement of the straightening vane assembly, please follow these steps:
1. Remove the retaining ring.
2. Pull out the old straightening vane assembly from the meter.
3. Pick up "Vane A" from the components received for the new assembly.
4. While holding such that the "ears" and slot are up, pick up "Vane B" and again,
with the ears up, slide it into slot of "Vane A".
5. Now pick up "Vane C" and with the ears up, slide it into position in the
assembly.
6. Find the (2) half rings and hold them on either side of the vane assembly,
just below the ears.
7. Drop the new assembly into the meter.
8. Reposition the retaining ring.
VANE A VANE B VANE C
STRAIGHTENING VANES
RETAINING RING
HALF RINGS
STRAIGHTENING VANE ASSY
▼
▼
▼
▼
2" Straightening Vane Assembly