Badger Meter Sanitary Valve - Manual (Page 10)

Page 10
9-11
Sanitary Control Valve
Valve Reassembly
1. Inspect the O-ring on stem to ensure proper position and sealing.
2. Insert the trim through the bottom of the bonnet.
3. Attach the union nut to the innervalve.
4. Inspect the sanitary gasket to ensure proper position and sealing.
5. Install the bonnet and trim subassembly into the body.
6. Tighten the sanitary clamp, holding the bonnet to the body by rotating the wing nut clockwise.
Actuator Reattachment
1. Screw the yoke locknut onto the body securing the body and the actuator together.
2. Pull the innervalve out of seat.
3. Connect the union nut with the innervalve and the Upper Connector nuts
4. Tighten the upper stem nut so that the pointer can be slid in between the two nuts.
5. Tighten the union nut to actuator stem.