Blue Angel Pumps BCP20ULS - Manual (Page 5)

5
Model BCP20ULS
www.blueangelpumps.com
Maintenance
(Continued)
2. Remove reservoir from deck by
unscrewing the four screws located
at the corners of the reservoir cover.
3. Remove the impeller cover by
unscrewing the five screws on the
underside of the motor. Pull out the
impeller shaft assembly.
4. Use a damp cloth to wipe off the
gasket and the motor assembly.
5. Reassemble impeller to motor. Then
reassemble reservoir to reservoir
cover.
CLEANING CHECK VALVE
1. Disconnect discharge line from
check valve – see Figure 8.
2. Remove check valve with 9/16”
wrench.
3. Visually check for obstructions or
damage.
4. If check valve is not damaged,
replace valve by hand-tightening.
Then tighten 1/2” turn with 9/16”
wrench.
Do not overtighten.
Damage to O-ring
seal may occur.
Notes
check valve
Figure 8 - Check valve