FUTEK LCM Series - Manual

This drawing is submitted solely for the information and
exclusive use of the original addressee. It is not to be divulged
in whole or in part, by any firm or individual without written
permission from FUTEK
Drawing Number: F3175
CAUTIONS
MOUNTING
TENSION LOADING MUST BE
IN LINE WHEN COMPENSATING
LINKAGES ARE NOT USED
LOAD MUST BE FLAT
AND PARALLEL WHEN
COMPENSATING LINKAGES
ARE NOT USED
1) DO NOT PULL ON OR CARRY SENSOR BY CABLE.
2) BE CAREFUL NOT TO APPLY FORCE ON OR MOUNT
WITH ANYTHING IN CONTACT OF THE DIAPHRAGM
(L1650 up to 1000 lb ONLY).
3) ANY TAMPERING OR REMOVAL OF COVER, CABLE
AND/OR CONNECTOR WILL VOID WARRANTY.
4) ALWAYS HAVE LOAD CELL PLUGGED IN DURING
INSTALLATION.
AVOID OR MINIMIZE
TORQUE DURING
INSTALLATION
ROD END BEARINGS WITH CLEVISES OR ALIGNMENT
COUPLERS MAY BE USED TO MAKE UP FOR
MISALIGNMENT
HIGH CAPACITY SENSOR
COULD BE USED TO
MONITOR WEIGHT
FOR CRANES
LOAD MUST BE EVEN,
CENTERED
AND IN LINE
CLEVIS
ROD END BEARING
(MALE OR FEMALE)
SENSOR MAY BE
USED TO
MONITOR
FORCES
IN AN ARBOR
PRESS
FEMALE TO FEMALE FEMALE TO MALE MALE TO MALE
L1650
DIAPHRAGM
1 2
3
6
4
5
7 8
ALIGNMENT
COUPLERS
(MALE AND
FEMALE)
ROD END BEARINGS ALIGHNMET COUPLERS
HIGH CAPACITYSENSORS
ARE USED TO MONITOR
FORCE APPLIED IN A
HYDROLIC PRESS