Kaman DIT-5200L - Manual (Page 11)

______________________________________________________________________________
Kaman Precision Products PART NO: 860522-001
www.kamansensors.com Last Revised 11/16/2012
- 11 -
PART 4 – CALIBRATION
The DIT-5200L systems are shipped from the factory pre-calibrated for a user specified
measuring range, sensitivity, and target material. They do not normally require calibration or re-
calibration. Potentiometer locations for the OEM and enclosure version are the same relative to
the sensor and I/O connector positions.
The system must be positioned to the null gap by first adjusting one sensor to the null gap and
adjusting the opposing sensor for a zero volt output. Reference section 3.2.
Figure 8 Sensor Positioning for Calibration