JLab Audio Shaker User Manual
Page 3
GET TO KNOW YOUR SHAKER!
Installation
1.
Remove the protective tape at the bottom of the Shaker to reveal the rubber stand for use on horizontal
surfaces.
2.
Do not throw away the protective tape as you will need to stick it back on the rubber stand when using a
mounting socket or suction cup
3.
Use a wet finger to clean any dust off the pad
4.
Carefully screw the speaker into the suction cup and mount to vertical surfaces such as windows to amplify
the sound.
5.
A screw mount is also provided to screw the speaker into a wall or wooden surface.
1st Step
– CHARGE IT!
1. Make sure the speaker is fully charged before initial use.
2. Connect the speaker via the Micro USB port to your PC or wall outlet using the Micro
USB cable and/or 5V Power Adapter.
6.
The Battery LED will illuminate in red while charging and will become green once
fully charged.
7.
JLab recommends charging the Shaker overnight with the Micro USB for optimum performance.
8.
If you encounter any issues while using your Shaker, please first check to ensure device is fully charged
before troubleshooting the issue and contacting Support.