JLab Audio Shaker User Manual
Page 4
2nd Step - POWER UP
1.
Once the Shaker is fully charged, locate the Power Button toggle switch (see second illustration above).
2.
Slide toggle to the right to power on. LED lights and sound should further indicate that the Shaker is on.
3. To power off, slide toggle to the left.
3rd Step - GET CONNECTED VIA BLUETOOTH
1.
Make sure the Shaker is turned ON (See 1st and 2nd Step)
2.
For Bluetooth, turn the switch to BT. When the Shaker is in pairing mode the LED light will slowly flash
green
3.
Enable the searching mode on your Bluetooth compatible device. (Most commonly found on your
smartphone under Settings, then Bluetooth, then by turning BT On / Searching for Devices.)
4. Select
“JLab Shaker” in the list shown on your Bluetooth device / smartphone.
5.
Enter “0000” if a password is required.
6.
When the Bluetooth connection is made, the LED will turn solid. Please allow 10
– 20 seconds for your
device to connect.
7.
Once connected, select your music, videos or calls and see your sound instantly amplified with the JLab
Shaker.
8.
Please note, only one device may be connected at a time. To connect another Bluetooth device, you must
disconnect from the Shaker from your device / smartphone.
9.
To reset the Shaker and void any existing connections,
flip the toggle switch to “Off” and back on. This will
put the Shaker back to pairing mode to search for Bluetooth devices
MAKE & RECEIVE TELEPHONE CALLS
1.
If a call is received while streaming music on speaker, the music will be muted and a ring tone will be heard
in its place.
2.
Answer and end calls by pressing the Play/Pause button once (see image above).
3.
Make calls by dialing on the cell phone and talking towards the speaker. Talk at a normal volume from 3
– 5
feet away.
4.
To decline an incoming call, hold the Play/Pause button (see image above) for 2
– 3 seconds or until the
phone call stops ringing and returns to your music.
4.
Check the instruction manual for your cell phone to ensure no further steps are required.
PLUG & PLAY NON BT DEVICES WITH AUX CABLE
1.
Connect the speaker with almost any audio device directly by using the supplied 3.5mm cable.
2.
Connect one end of the 3.5mm cable to the audio in port on the Shaker and the other end of the cable to the
3.5mm audio port on your favorite devices.
3.
While connected, this 3.5mm aux line in will override any Bluetooth wireless music being played. Once the
3.5mm device is disconnected from the aux connection, the Shaker will return to the music on the Bluetooth
connected device.