Prochem Legend GT - Manual (Page 19)

17
Installation
Van Bulkhead Installation
1. Select a location on the vehicle floor to drill the hole for the bulkhead adapter. This location should be situated
in a position that eliminates the possibility of fuel line contact by either the operator(s) or accessories during the
working hours or maintenance periods. Make certain that the supplied hoses will reach the location and work
with the configuration you choose.
2. Drill a 5/8" (.625) diameter hole through the vehicle floor at the installation point chosen for the bulkhead.
3. Install the 1/8 NPT bulkhead adapter by inserting the adapter and tightening the nut on the opposite side of the
van floor.
4. Attach the 1/8 NPT x 1/4 Hosebarb 90 degree elbow to the bulkhead inside the van to connect the fuel system
to the console.
5. Attach the 1/4" fuel hose from the console to the 1/4” Hosebarb 90 degree elbow on the bulkhead.
TO CONSOLE
USE AS NEEDED
BULKHEAD ADAPTER
BULKHEAD NUT
HOSEBARB ELBOW
HOSEBARB ELBOW
HOSE MOUNTING CLAMPS
FUEL HOSE
HOSE CLAMP
VEHICLE FLOOR
5/8" DIA HOLE
LOCTITE
BYPASS FUEL FILTER
FUEL HOSE FROM
BULKHEAD GASKET
BULKHEAD GASKET
86313050 LEGEND GT