Prochem Legend GT User Manual

Page 33

Advertising
background image

31

Operations

Pre-Run Inspection / Setup

NOTE: Operation of this unit is simple. However, only
trained personnel should proceed.

Operate this unit and equipment only in a well-
ventilated area. Exhaust fumes contain carbon
monoxide, which is an odorless and deadly poison
that can cause severe injury or fatality. DO NOT
operate this unit where the exhaust may enter any
building doorway, window, vent, or opening of any
type.

Check For Adequate Fuel

Check the fuel tank to be certain there is adequate fuel
to complete the job. This unit uses approximately .75 –
1.00 gallons of fuel per hour, depending on the speed
setting.

Remove Tools From Vehicle

Remove any tools or hoses from the van, which you will
require.

Water Supply Connection

NOTE: Before connecting your water hose to the
supply faucet, flush out the faucet until the water is
free of any debris. Flush out any debris which may be
in your water inlet hose.

1. Connect the water supply hose to the water inlet

quick-connect on the right side panel of the
console. Connect the hose to the water supply
faucet.

NOTE: Never use your waste pump outlet hose as a
water inlet hose. Use only clean hoses for water inlet.

2. Turn the water supply faucet on. The water will fill

the water box.

Don't run the solution pump dry, damage may
occur and void the warranty.

In the event the pump is run dry, allow the pump to
cool down to ambient temperature before reintro-
ducing water. Otherwise major damage may occur
and void the warranty.

High Pressure Solution Hose

Before starting the unit, connect the high pressure
solution hose to the outlet connection at the front of the
unit. Connect the cleaning tool to the pressure hose.

Vacuum Hose

Connect the vacuum hose to the vacuum inlet connec-
tion at the front of the unit. Connect the other end of the
vacuum hose to the cleaning tool.

Filters

Ensure all filters on machine and in waste tank are free
of debris.

DANGER

WATER UNDER HIGH PRESSURE AT HIGH
TEMPERATURE CAN CAUSE BURNS,
SEVERE PERSONAL INJURY, OR COULD
BE FATAL. SHUT DOWN MACHINE,
ALLOW TO COOL DOWN, AND RELIEVE
SYSTEM OF ALL PRESSURE BEFORE
REMOVING VALVES, CAPS, PLUGS,
FITTINGS, FILTERS AND BOLTS.

DANGER

DO NOT MODIFY
UNIT WITHOUT
WRITTEN
PERMISSION
FROM
MANUFACTURER

ROTATING
MACHINERY.
WATER UNDER
PRESSURE AT HIGH
TEMPERATURE.
IMPROPER
MODIFICATION OF
EQUIPTMENT CAN
CAUSE SEVERE
PERSONAL INJURY
OR COULD BE
FATAL.

86313050 LEGEND GT

Advertising