ProMariner ProNautic C3 - Manual (Page 4)

14 3
C a u t i o n s , W a r n i n g s & S a f e t y I n s t r u c t i o n s A c c e s s o r i e s
Important Safety Instructions Continued
7. WARNING – RISK OF EXPLOSIVE GASES.
a) WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES
GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS
REASON, IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR
CHARGER, YOU READ THIS MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.
b) To reduce risk of battery explosion, follow these instructions and those published by
battery manufacturer and manufacturer of any equipment you intend to use in vicinity of
battery. Review cautionary marking on these products.
8. PERSONAL PRECAUTIONS
a) Someone should be within the range of your voice or close enough to come to your
aid when working near a lead acid battery.
b) Have plenty of soap and water nearby in case battery acid comes in contact with skin,
clothes or eyes.
c) Wear complete eye protection and clothing protection. Avoid touching eyes while
working near battery.
d) If battery acid contacts skin or clothing, wash immediately with soap and water. If acid
enters eye, immediately flood eye with running cold water for at least 10 minutes and get
medical attention immediately.
e) NEVER smoke or allow a spark or flame in vicinity of battery or engine.
CAUTION - To reduce the risk of injury, charge only lead acid type rechargeable batteries
(Flooded, Sealed Flooded, GEL (Gelled Electrolyte Lead Acid) cell or AGM (Absorbed
Glass Mat)). Other types of batteries may burst, causing personal injury. The ProNautic
is factory set for Flooded Lead Acid batteries (Position selection 6).
Check the position
of the battery type selector switch before applying power to insure the charger is in the
correct setting for the battery type. This switch is located on the DC end of the charger
see Page 7.
Incorrect assembly may result in electrical shock or fire.
f) Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark
or short-circuit battery or other electrical part that may cause explosion.
g) Remove all personal metal items such as rings, bracelets, necklaces, watches, and
jewelry when working near a battery. A battery can produce a short circuit current high
enough to weld a ring or any other metal, causing serious burns.
h) Do not use the battery charger to charge dry cell batteries that are commonly used
with home appliances i.e. a cordless power drill battery. These batteries may burst and
cause injury to persons and damage to property.
i) NEVER charge a frozen battery.
model part no. cable size volts banks
ProNautic Helm Control & Display 63003 30' n/a n/a
Handheld DC System Tester 87710 n/a n/a n/a
Digital Multi-Meter 60016 3' 12 n/a
Clamp-It Multimeter 87015 n/a n/a n/a
ProSafe 1 Single Line Galvanic Isolation System 22086 n/a 120 n/a
ProSafe Isolation Transformers 3.6-12KVA n/a n/a 120/240 n/a
Adjustable Corrosion Monitoring System 22020 n/a n/a n/a
Corrosion Monitoring System 22030 n/a n/a n/a
Corrosion Workbook 20001 n/a n/a n/a
Accessories
To Place an Order Please Contact Your Local Dealer or ProMariner at:
Tel: 603-433-4440 / Fax: 603-433-4442 / www.promariner.com
87015
ProNautic Helm Control & Display Remote
The helm control display remote allows the
user to control the charger and view the
operation of the battery charger. Part# 63003
Corrosion Control & Monitoring
ProMariner makes a variety of corrosion
control products that make isolating and
monitoring AC power easier.
Corrosion Control Workbook
Educate yourself on the process of performing
a galvanic survey.
(Recommended with
Corrosion Test Meter Part # 20006)
Test Meters
ProMariner makes a variety of test meters for
use on testing battery and current.
60016
22030 & 22020 20001
22086
63003