UEi Test Instruments AK900SC - Manual (Page 8)

8
5 Vent
Allows for atmospheric and internal pressure adjustment without
moisture entry. Do not cover this port.
6 Temperature Probe
The temperature probe can be secured onto piping from 3/8” to 3” in
outer diameter (1 to 7.5cm) with the attached hook-n-loop strap. The
connectors are water resistant when mated or when covered by their
protective caps. For accurate measurements, use a piece of pipe
insulation over the sensor and pipe to insulate them against the
ambient air.
To install the connector, align the key on the plug with the slot on the
connector. Push connector while
wiggling to mate together, and then
tighten the thread on the blue collar to
lock connector into place. When not
in use, apply the attached cover to the
connector to keep moisture and dirt
out. The probe comes with a 10’
(3m) long cord.
Display
The display of the unit is very user friendly. For users familiar with
traditional manifold gauges, the readouts should be self-explanatory.
The quantity of information offered to the user is more than any other
gauge traditionally available. A full understanding of these features
allow for rapid system analysis, for easier and more accurate trouble-
shooting.