Brother HL 4570CDWT - Manual (Page 26)

Configuring your machine for a wireless network (For HL-4570CDW(T))
21
3
Note
• If you configure your machine using EAP-TLS Authentication, you must install the Client Certificate before
you start configuration. If you have installed more than one certificate, we recommend you write down the
certificate name you want to use. For installing the certificate, see Using Certificates for device security
on page 60.
• If you verify your machine using the Common Name of the Server Certificate, we recommend you write
down the Common Name before you start configuration. Contact your network administrator about the
Common Name of the Server Certificate.
b Press + or - to choose Network.
Press OK.
c Press + or - to choose WLAN.
Press OK.
d
Press + or - to choose Setup Wizard.
Press OK.
e
When WLAN Enable? is displayed, press + to accept.
This will start the wireless setup wizard.
To cancel, press Cancel.
f The machine will search for your network and display a list of available SSIDs.
You should see the SSID you wrote down earlier. If the machine finds more than one network use + or
- key to choose your network, then press OK. Go to step j.
If your access point is set to not broadcast the SSID, you will have to manually add the SSID name. Go
to step g.
g Choose <New SSID> using + or -.
Press OK. Go to step h.
h Enter the SSID name. (For information how to type text, see the Quick Setup Guide.)
Press OK. Go to step i.
i Using + or -, choose Infrastructure when instructed.
Press OK.