Brother PT-H500 - Manual (Page 31)

31

G
E
TTI
N
G
STA
R
TED
Feeding Tape

Auto Power-Off Time

Feed & Cut
The Feed & Cut function feeds 0.96" (24.5mm) of blank tape, and then cuts the tape.
Press the Feed & Cut key.
"Feed & Cut?" will appear on the LCD display.
Using the or key to select the "Feed & Cut", and then press either OK or Enter
key. The message "Feeding Tape... Please Wait" appears while the tape is fed, and
then the tape is cut.
Attribute Value Attribute Value
AC Adapter Off Li-ion Battery Off
10min. 10min.
20min. 20min.
30min. 30min.
40min. 40min.
50min. 50min.
1hr. 1hr.
2hr.
4hr.
8hr.
12hr.
• If you connect the AC adapter to the P-touch labeler after you specified “Auto Power
Off”, the setting for “AC Adapter” becomes valid.
• If you disconnect the AC adapter from the P-touch labeler after you specified “Auto Power Off”:
• When alkaline batteries are used, the auto power-off time is fixed to 20 minutes.
• When the Li-ion battery is used, the power turns Off immediately.
• The default value is "1hr." for the AC Adapter and "30min." for the Li-ion battery.
Feeding Tape
• Be sure to feed tape to remove any slack in the tape and ink ribbon after inserting the
tape cassette.
• Do not pull the label coming out of the tape exit slot. Doing so will cause the ink
ribbon to be discharged with the tape. The tape may no longer be functional
after the ink ribbon discharges.
• Do not block the tape exit slot during printing or when feeding tape. Doing so will
cause the tape to jam.
1
2
To exit or cancel this function press Esc.