Brother PT-1910 - Manual (Page 32)

24
3 Press r. The text is automatically formatted for the installed stamp: centered within
the preset message area with the tape length and margins automatically adjusted.
4 Press p to cut the text out of the stamp stencil film.
5 After the stamp stencil film is cut off, remove the backing paper from the stamp stencil
film and affix it to the ink pad of a stamp film holder.
EXAMPLE
To cut a stamp:
1 Enter the text and insert a stamp film cassette in the tape compartment.
2 Hold down c and press U .
3 Press
r
.
4 Press p to engrave the stamp stencil film, and
then automatically cut it off.
To affix a stamp:
5 Remove the stamp frame from around the stamp
film holder ink pad, one side at a time, and then
remove the protective seal covering the ink pad
and the backing paper from the stamp stencil film.
6 With the glossy side of the stamp stencil film
upward, align one of its ends with the slit on the
side of the stamp film holder.
F O R M A T ?
S T A M P
2: 1 2 3 4 M a i n
1: J S m i t h
1 / 1
C O P I E S
Tape end
Glossy side
Slit