Aga Ranges Pro+ Dual Fuel U110054 - Manual (Page 15)

13
Accessories
Oven racks
Each range is supplied with the following:
2 full width racks (Fig.2-39)
1 telescopic rack with runners (Fig.2-40)
2 broiler pans with grids (Fig.2-41)
3 energy saving racks (Fig.2-42)
2 sets of side rack supports (Fig.2-43)
1 energy saving divider (Fig.2-44)
The oven shelves are retained when pulled forward but can
be easily removed and refitted.
To remove and refit the racks
The rack has a small kink on either side (Fig.2-45). To remove
the rack, line these up with the stops in the rack support
(Fig.2-46). Lift the rack upwards so that it will pass over the
rack stop and then pull it forwards (Fig.2-47).
Refit in the reverse order, making sure to push it fully back.
To remove and refit the telescopic rack and runners
Slide the rack out on the runners. While holding one of the
runners securely, carefully lift the rear of the rack upwards:
the rack will spring clear of the central restraining tab. Repeat
for the opposite side of the rack.
Note: To aid the removal of the shelf you can insert a suitable
flat tool through the opening in the side of the runners and
lever the rack clear (Fig.2-48).
Tilt the front of the rack downwards and then lift clear of the
runners (Fig.2-49).
Refit in the reverse order, making sure to push the rack down
onto the runner arms.
To remove and refit the ladder rack supports
Lift the ladder support hooks out of the two locating holes in
the oven side (or divider) before lifting the support clear of
the bottom ladder restraint.
Refit by inserting the bottom of the ladder into the restraint
before fitting the hooks through the locating holes.
ArtNo.326-0013 - Full capacity shelf
(Falcon)
Fig.2-39 Fig.2-40
ArtNo.331-0008 - 90SC
grill pan & trivet
Fig.2-41
ArtNo.326-0002 - Energy saving shelf
Fig.2-42
Fig.2-43
ArtNo.281-0028 - Albertine divider
Fig.2-44
Fig.2-45
Fig.2-46 Fig.2-47
Fig.2-48
Fig.2-49