Aga Ranges Pro+ Dual Fuel U110054 - Manual (Page 29)

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
27
ArtNo.010-0002 Rear roller nut
Fig.7-5
Fig.7-3
ArtNo.325-0002 - BI oven removing the door
Fig.7-4
ArtNo.010-0010 Lowering the rear rollers (90)
x10
Fig.7-6
Fig.7-7
Moving the Range
 The range is very heavy. Take great care.
We recommend two people maneuver the range. Ensure that
the floor covering is firmly attached or removed to prevent
it being disturbed when moving the range around. You will
need the leveling tool.
Removing the Oven Door
To remove the door, open the door fully. Swivel the locking ‘U’
clips forward to the locking position (Fig.7-3). Grip the sides
of the door, lift upwards and then slide the door forwards
(Fig.7-4) and remove.
Removing the Storage Drawer
Pull the drawer right out.
Push the ends of the plastic clips – down on the left-hand
side, up on the right-hand side – to release the catches
holding the drawer to the side rails (Fig.7-5). At the same
time pull the drawer forwards and away from the side rails.
For safety’s sake push the drawer rails back out of the way.
Put the drawer somewhere safe – do not replace it until you
have completed the installation, you will need access to the
area behind the drawer.
When you have removed the oven door and storage drawer
continue as follows:
First fit the leveling tool on the hexagonal adjusting nut
(Fig.7-6).
Make 10 complete (360°) turns clockwise (Fig.7-7). (This
means turning and removing the leveling tool 20 times.)
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the range.
Note that the rollers are only intended to aid installation – the
range should not be moved once it is installed.