Brother ADS-1000W - Manual (Page 243)

Appendix
229
B
1 When the LED is available:
Otherwise:
2 When a plastic card is inserted into the machine:
Otherwise:
3 When all LEDs except the WiFi light are off:
Otherwise:
One-push
WLAN Setup
Error
The machine cannot detect a
wireless access point/router
that has WPS or AOSS™
enabled. To configure your
wireless settings using WPS
or AOSS™, you must operate
both your machine and the
wireless access point/router.
Confirm your wireless access
point/router supports WPS or
AOSS™, and try setup again.
If you do not know how to
operate your wireless access
point/router using WPS or
AOSS™, see the
documentation provided with
your wireless access
point/router, ask the
manufacturer of your wireless
access point/router, or ask
your network administrator.
One-push WLAN setup failed.
Turn the machine off and on,
and then try setup again.
Two or more wireless access
points that have WPS or
AOSS™, enabled are
detected. Do one of the
following:
 Confirm that only one
wireless access
point/router within range
has the WPS or AOSS™
method active and try
setup again.
 Try setup again after a few
minutes in order to avoid
interference from other
access points.
Status Descriptions