Brother HL-8050N - Manual (Page 145)

6 - 5 ROUTINE MAINTENANCE AND CONSUMABLE ITEMS REPLACEMENT
Replacing the Fuser Unit & Transfer Roll Cartridge
(FP-8000)
The fuser unit and transfer roll cartridge are consumables. For more information about consumables, see
Introduction to the Optional and Consumable Items on page A-1.
For details about when to change consumables, see Life Span of Consumable Items on page A-31.
Fuser Unit & Transfer Roll Cartridge Handling Precautions
■
Never touch the labeled area found on or near the heat roller. You can get burnt. To avoid
injuries or burns, if a sheet of paper is wrapped around the heat roller, do not try to remove it by
yourself. Switch off the printer immediately, and contact
Brother Customer Service.
■
Be sure to switch off and unplug the printer before accessing the interior of the printer for
cleaning, maintenance, or fault clearance. Access to a live printer’s interior can cause electric
shock.
■
Never throw a transfer roll cartridge into a naked/open flame. It can cause an explosion and you
can get burnt.
Handling Precautions
■
Do not replace the fuser unit immediately after using the printer. You may get burnt.
■
Do not remove and reinsert the transfer roll cartridge in use.
■
When the message to replace the transfer roll cartridge appears, replace the transfer roll
cartridge immediately. Otherwise, the printer will stop printing.
Replacing the Fuser Unit & Transfer Roll Cartridge
1
Turn off the printer power switch and leave it for 30
minutes until the fuser unit cools down.
WARNING